AGF Type
6-Ampoule Filling-sealing Machine
Introduction:
The 6-ampoule filling-sealing machine AGF is suitable for the technological
requirements of water and powder injections. It features high capacity,
good quality, stable operation, and so it is an ideal equipment for ampoule
medicine production.
Upside of the filling-sealing
machine is set of one hundred stage laminar flow purifying protection.
There is set to prevent
from filling on filling-sealing machine.
Liquefacient gas and
oxygen is adopted as filling burning gas on filling-sealing machine.
Stand-rotation sealing
is adopted on filling-sealing machine, sealing quality is good.
Tiny-adjustment is adopted
for filling on filling-sealing machine, error is smaller is filling value.
Under the control of buffer, filling-sealing machine can mate with production.
AGF Type 6-Ampoule Filling-sealing Machine Operating Theory: Ampoule-bottles
are putted into passage for bottle entrance in bulk by the transmission
belt of AGF mold 6 ampoule filling-sealing machine, under the control
of barrier six ampoule-bottles are segregated every time, then carried
to filling unit and stealing by teeth-plate in interval. The filling and
stealing is under the protect of one hundred stage lamina flow. Sealed
ampoule-bottle is putted outside bottle-pusher.
AGF Type 6-Ampoule Filling-sealing Machine Technical
Data:
Power:
380V, 50HZ
Gross power of motor: 1.5Kw
Volume of liquid gas: 1.2m3/h
Volume of oxygen gas: 0.6m3/h
Speed control: 30~60r/min (stepless speed adjustment).
Weight: about 1400kg
Overall size: 2500X1200X2250mm
Output:
Ampoule
1ml
11500 piece/h 2ml 11500 piece/h
5ml 10000 piece/h 10ml 8000 piece/h
20ml 6000 piece/h
Operating
Procedures:
Before
starting up, washing the filling pump, sampling and test, the clarity
must be accord with the standard specified by the pharmacopoeia.
Adjust
the pump stroke with a fine-regulating bolt, until get the best stroke,
then adjust the dosage with fine regulation switch, make it up to standard
and without any dripping.
Set
the fillers’ position correctly in order to avoid it touching ampoule
neck.
Before
ignition, make sure that oxygen, nitrogen, liquefied, natural gas and
the air for suction is enough. First, open the burning gas valve, then
open the oxygen valve and adjust the valve to have fire properly. Before
stop machine, should turn off the oxygen valve. After about one minute,
close the gas to prevent the return fire burning down the tubes.
|
